MAINTENANCE
1.
Hopper
: We recommend that the hopper be emptied after
each use.
2.
Clean the hopper and machine
by wiping with a dry cloth
as needed.
3.
Brushes
: After each use, remove any strings or debris.
See Step 5 for cleaning and replacement.
4.
Replacement or Cleaning of the Angled Wheels (D)
: Set
the height adjustment dial to position 8. Pull the angled
wheel (D) strongly, to remove it and its axle from the tooth
sleeve. Clean or replace the wheel, then push it firmly
back into the tooth sleeve. Make sure you place the wheels
back in their correct positions, they are marked L and R
for the left and right positions.
5.
Cleaning or Replacement of the Brushes (B) and Nylon
Gear Casing (C):
Remove the angled wheel (D) as ex-
plained in Step 4. Pull the brush towards you - the brush
and gear will come away from the pivot housing. The
gear can now be pulled away from the brush. The brushes
and gears may be cleaned with water. The gears should
only be lubricated with silicone spray.
Ensure that the brushes and gears are fitted on the cor-
rect side of the sweeper when reassembling. To guide
you, the inside of the front cover is marked L and R, as are
the wheels (D) and each brush is marked L/// and R\\\
which indicates the direction of the bristle point. To reas-
semble, place the brush over the pivot housing then push
the nylon gear (C) over the pivot housing. Refit the
angled wheel.
Summary of Contents for MS-29
Page 4: ...MS 21 MS 29...
