INSTRUCTIONS FOR USE
ENGLISH
9100001306 - Jaguar 26R
17
04/2015
MACHINE OPERATION (SCRUBBING/DRYING)
1. Start the machine as shown in the previous paragraph.
2. If necessary, adjust the solution quantity by pressing the switches (59 and 60).
3. If necessary, to reduce the noise, turn on the mute function by pressing the switch (55).
NOTE
It is suggested to use the mute function only on smooth floors without joints.
NOTE
For correct scrubbing/drying of floors at the sides of the walls, TRIPLE S suggests to go near the walls with the right side
of the machine as shown in figure 2.
A
A
B
Figure 2
P100364
Squeegee adjustment
4. If necessary, stop the machine and turn the squeegee balance adjusting handwheel (35) so that the rear blade - in all its length
- touches the floor.
Adjustment of the detergent concentration in the solution
The system used to mix the detergent with the washing water can be activated by pressing the detergent flow control switch (A, Fig.
3): when the LED (B) is on, the detergent is added to the washing water.
The display (C) shows the detergent concentration level in the solution as shown in the table in Figure 3.
NOTE
The detergent concentration in the solution dispensed from the system always corresponds to level 1. In order to
temporarily obtain a stronger concentration, press the EcoBoss switch or disable the EcoBoss (see the relevant
paragraph).
EcoBoss function
Lift the EcoBoss lever (D, Fig. 3) whenever a stronger washing power is required.
When lifting the lever (D) (LED (E) flashing) the solution flow increases, the extra pressure function activates and the detergent
concentration in the corresponding solution rises to the set level (moreover, if the detergent mixing function is not activated, it
activates automatically).
The original settings can be restored by lifting the lever (D) once again (LED (F) on).
NOTE
If the lever (D) is not lifted once again, the original settings are restored automatically after 60 seconds.
In order to change the actual detergent concentration, proceed as follows:
1.
Turn off the detergent flow control switch (A) (the LED (B) must be OFF).
2.
Press and hold the detergent flow control switch (A) until the LED (B) flashes.
3. Release the switch (A). Press it again shortly to go to the next level shown by the display (C) as shown in the table in Figure 3;
repeat the procedure until the desired setting is reached.
4.
Wait until the LED (B) stops flashing: the new level is now set.
NOTE
Detergent percentage setting is stored into memory, even if the machine is turned off.
