8
DISPLAY
The IP address and subnet mask of the MC6N is shown on the LCD display for a few seconds
after power-up. The factory default IP address is 192.168.0.250. This can be changed using
the IP_ADDRESS command via the
Motion
Perfect software toolor SD Card.
Display
Example
Description
Details
SYS
Displayed on
controller
start
960
Model code :
Displayed on
power up
P960 : 2 axes
P961 : 4 axes
P962 : 8 axes
P963 : 16 axes
P964 : 32 axes
P965 : 64 axes
192.168.0.250 IP Address :
Displayed on power up OR after
ethernet connection for 15
seconds
Enable status
Error codes
Ann : Error on Axis nn
Unn : Unit error on slot nn
Caa : Configuration error on
unit nn, ie: too many axes
E04 : VR/TABLE corrupt entry
IP Address / Run / Error code
(see table below)
EtherCAT Communications
active
EtherCAT detection (flashing)
EtherCAT detected (steady)
I/O channels On / OFF
Error
Enable status LED
Power LED
