FEATURES
1. Vertical axis has high sensitivity and wide bandwidth
and especially covers fully specified frequency
response at 5mV/div for all models.
CS-1060 ;
1mV/div, 2mV/div : DC to 20 MHz, - 3 dB
5mV/div : DC to 60 MHz, - 3 dB
CS-1040 ;
1mV, 2mV/div : DC to 1 5 MHz, - 3 dB
5mV/div : DC to 4 0 MHz, - 3 dB
2. Vertical sensitivity range is selectable from 1mV/div to
5V/div with rotary switch continuously.
3. Time base permits the high sweep speed.
CS-1060; 5nsec/div ( x 10 MAG)
CS-1040; 10nsec/div ( x 1 0 MAG)
4. Vertical sensitivity error and sweep rate error are
± 3 % and accurate measurements are provided.
5. The 150 mm rectangular, domed mesh type CRT with
internal graticule provides high brightness and ac-
curate measurements, free of parallax error.
CS-1060; acceleration voltage; 16 kV.
CS-1040; acceleration voltage; 12 kV.
6. For convenience in making rise time measurements,
the 0 % , 1 0 % , 9 0 % and 1 0 0 % levels are marked on
the graticule scale of the CRT.
7. The built-in Auto-focus circuit keeps the waveforms in
clear focus automatically regardless of the INTENSITY
control setting.
8. Trace rotation is electrically adjustable from the front
panel.
9. By SCALE ILLUM control, the waveform is easy
observed in darkened area and the photograph of the
waveform is easy provided a single photograph of the
waveform superimposed on the graticule scale.
10. Delay sweep modes are available in not only Con-
tinuous Delay (STARTS AFTER DELAY) and trigger
Delay (TRIG) but also both A and B zero Delay (DELAY
TIME ZERO) allowing to observe the whole extent of
any complicated pulse train with magnifiction as
necessary.
1 1 . Single sweep permits viewing and photographing one-
time events.
12. TRIPLE mode presents a triple-trace oscilloscope; even
six traces of waveforms may be observed simultane-
ously with HORIZ DISPLAY set at ALT.
13. The delay line permits viewing of leading edge of high-
frequency, fast risetime pulses.
14. Selectable AUTO FREE RUN function provides sweep
without trigger input signal.
15. The FRAME-LINE switch provides selection of sync
pulse for sweep triggering from small amplitude to
large amplitude without adjusting when viewing com-
posite video waveforms.
16. Vertical mode automatically provides the trigger signal
with TRIG SOURCE and V. MODE switches.
17. X-Y operation is easy provided by one-touche.
18. Provides with CH1 OUTPUT terminal to monitor input
signal of C H 1 .
19. SWEEP GATE and SWEEP OUTPUT terminals are pro-
vides.
20. DELAY TIME MULT permits the accurate time
measurements with the dial scale.
3
Summary of Contents for CS-1040
Page 1: ...CS 1 OBO CS 1 0 4 0 TRIPLE TRACE OSCILLOSCOPE INSTRUCTION MANUAL T R I O...
Page 33: ...MEMO 3 3...
Page 34: ...MEMO 3 4...
