13
12
Method Of Usage
Method Of Usage
5.Am rest installation
Arm rest covered on the fixed steel board, then press the armrest make sure the
pin into the box on the fixed steel board, and pull it with your hand to check it is
fasten tightly.(figure 7)
Find out the install hole on the front part of the fixed steel board, screw the screws
with hex wrench.
Figure 8
Find out the install hole on the behind part of the fixed steel board, screw the
screws with hex wrench, finish the installnation, the same installnation of the two
armrest. (figure 9)
( Figure 7)
( Figure 8)
( Figure 9)
P
R
E
S
S
IT
D
O
W
N
W
A
R
D
G
E
N
T
L
Y
Armrest
Seat cushion
Calf rest
Figure: hex head screw
fixed in front part of armrest
Armrest
back cover
Figure: hex head screw
fixed in behind part of armrest
Find out the air tube fitting and corresponding plug connector from the bottom of
the seat frame and armrest, get through from the square hole on the fixed iron
plate. (Figure 1)
After the plug connector get through from the square hole on the fixed iron plate,
aligned to the corresponding connection plug. (Figure 2)
Pull
Figure 3
Figure 4
Figure 5
Figure 6
Take the butt joint out from the bottom of the seat frame and plug into the
connector on the armrest, and the air tube fitting plug well too. (Figure 3)
After finish the connecting of the plug, put it in the bottom of the seat frame
through the square hole on the fixed iron plate, avoid to folding of the air tube.
Make the male pin on the armrest corresponding to the female pin on the fixed
plate, the outline of the iron plate corresponding to the concave outline of the
armrest. (Figure 5)
Holding the armrest and aligning the two male pin on the armrest on the female
pin on the iron plate (Observe whether the connecting line was in the bottom of the
seat frame to avoid to get stuck), the whole armrest hitched on the fixed iron plate.
Note: the connecting line must
to be stuffed in (avoid to get stuck)
Figure 1
Figure 2