ASSEMBLY INSTRUCTIONS
© 2021 TRINITY - 800.985.5506
3
STEP 3
D (2)
E (2)
F (16)
Lay WORKBENCH (A) on its backside. Two people
are needed. Do NOT attempt this alone.
Position LOCKING CASTERS (D) on the side of
WORKBENCH (A) of your choice and align holes to
pre-installed nuts on the underside of
WORKBENCH (A). Use a 14mm socket wrench to
fully tighten CASTER BOLT (F) to WORKBENCH (A).
Repeat to install NON-LOCKING CASTERS (E).
Notes:
* Make sure to install both of LOCKING CASTERS
(D) on the same side.
** For ease of use, place LOCKING CASTERS (D) on
the side you will regularly push or pull.
*** If you plan to push the workbench against a
wall, place LOCKING CASTERS (D) on the front long
side for ease of access.
14mm
A
Carefully lift Workbench upright. Two people are
needed. Do NOT attempt this alone.
SHELF (I) is shipped at the bottom inside the cabinet.
Tilt SHELF (I) diagonally and remove it from the
cabinet.
Attach SHELF SUPPORT (J) by hooking it over the
position tab at the desired height. Make sure all
four SHELF SUPPORTS (J) are at the same level. Tilt
SHELF (I) diagonally to move it inside the cabinet.
Place SHELF (I) on top of all four SHELF SUPPORTS (J).
You can adjust the shelf height position by re-
attaching shelf supports and re-locating the shelf.
I (1)
STEP 4
E
D
F
I
Position Tab
J (4)
J
