HANDING DETERMINATION
Door handing is determined by
the position of the hinges, as
viewed from the outside of the
room or building. If the door
hinges are on the left, the door
is termed left handed; if the
door hinges are on the right,
the door is termed right
handed. Also a door is either
inswinging (opens into the
room), or outswinging (opens
to the outside of the room).
LEFT HAND (LH)
RIGHT HAND (RH)
OUTSIDE
LEFT HAND
REVERSE (ORDER RH)
RIGHT HAND
REVERSE (ORDER LH)
OUTSIDE
DOOR HANDING GUIDE
HANDING OF DOOR IS ALWAYS DETERMINED FROM THE OUTSIDE.
Slider Guard
Prepare the Latch for
assembly. Position the
Latch and Latch
Spring as shown and
pass the assembly pin
through the two parts.
Insert the Slider as
Fail-Secure or
Fail-Safe position
as shown.
Disassemble the Back Cover and the
solenoid of the Left Hand configured
EN strike.
Using the Assembly Pin, push the
Latch Pivot Pin out.
Take the Latch & Spring and the
Slider Guard out of the frame.
Disassemble the Back Cover and the
solenoid of the Right Hand configured
EN strike.
Using the Assembly Pin, push the
Latch Pivot Pin out.
Take the Latch & Spring and the Slider
Guard out of the frame.
Pass the long leg of the Spring
through the rectangular hole on
the frame and let the Latch
assembly drop to position where
all the pivot holes lines up.
Pass the long leg of the Spring
through the rectangular hole on
the frame and let the Latch
assembly drop to position where
all the pivot holes lines up.
Assemble the Solenoid and
secure it with the solenoid Screw
as shown.
Finish the assembly by installing
the Cover and securing it with the
two assembly Screws.
Assemble the Solenoid and
secure it with the solenoid Screw
as shown.
Finish the assembly by installing
the Cover and securing it with the
two assembly Screws.
Fail-Secure
Slider position
HANDING THE STRIKE (RIGHT HAND)
HANDING THE STRIKE (LEFT HAND)
Fail-Safe Slider
Slider position
Fail-Secure
Slider position
Dimple shows
Fail-Safe
Slider position
Fail-Safe Slider
Slider position
Dimple shows
Fail-Safe
Slider position
Assemble the Slider Guard over the Slider.
Assemble the Slider Guard over the Slider.
Align the Slider with
the pick guard ribs
as shown.
Align the Slider with
the pick guard ribs
as shown.
1
1
2
2
3
3
3
4
5
A
below
A
below
7
7
8
LATCH ASSEMBLY
400 LATCH
FOR CYLINDRICAL
& MORTISE LOCKS
RP LATCH
FOR RIM PANIC
DEVICES
At 5 (Below) you
may switch out the
standard
Cylindrical/Mortise
Latch for the RP
(rim panic) Latch.
Note:
RP Latch is
NOT Fire Rated
(it is Outdoor rated)
A
SWAP LATCHES
Latch Pivot Pin
Assembly Pin
Latch Pivot Pin
Assembly
Pin
6
6
Insert the Latch Pivot Pin
making sure that the flared pin
head is towards the right as shown.
Pass the Latch Pivot Pin through the
Frame, Latch and Spring.
(The assembly pin will fall off the opposite end.
Save this pin for future use.)
Insert the Latch Pivot Pin
making sure that the flared pin
head is towards the left as shown.
Pass the Latch Pivot Pin through the
Frame, Latch and Spring.
(The assembly pin will fall off the opposite end. Save
this pin for future use.)
