7
ROSIN PRESS OPERATION
8
Program optimal press platen temperature into temperaure control (PID) units. Typically
press operation will be between 195 to 220 degrees fahrenheit.
To adjust set value temperature on PID control push and hold up arrow button for three
seconds.
Wait at least 15 minutes after Rosin Press starts for press platens to reach desired and
stable temperature. Note that some slight fluctuation is normal.
Insert prefilled filter bag packet(s) and PTFE catchment paper between press platens. To
optimze press performance, position bags close to center of press platen surface. Multiple
small bags may be used.
Close press platens by activating hydraulic pump, either by hand unit or with power pump
options. Pressure gauge on pump will read approximately 500 psi. Wait until liquid can be
seen forming along packet edges, then slowly increase pump pressure to 7000 psi. Com-
bination of heat and intense prssure will push out all liquid rosin material from filter bag
packets.
Maximum recommended pressure as viewed on pump gauge is 7000 psi.. Approximately
20 Tons at press platens.
When all rosin has been extracted, release pump pressure. Platens will return to open posi-
tion. Remove spent filter bag packet and catchment paper, reload with fresh material, and
repeat press operation.
When filter bag packet and catchment paper have cooled sufficiently, dried rosin material
may be removed.
Increase temperature
Press and hold the up button for 3 seconds. At desired
temp, press the set button.
Decrease temperature
Hold the up arrow for 3 seconds. Then, press the down
arrow until the desired temp is shown. Press the set
button.
Check current temperature setting
Press the up button and the set temp will show. Press
the set button, and the current temp will show again.
Summary of Contents for Rosin TRP stack
Page 1: ...RosinTRPstack OWNER S MANUAL V 1 4...
Page 16: ......
