Trilogy Orator, Installation Manual

Page: 27 / 37

Orator Installation Guide
Issue 2 Trilogy Broadcast Limited Page 27 of 37
Orator
4.4.3 Typical expansion panel configuration
Since the 500-30 series panels (“Standard” 8 / 16 / 24 key) only have a single expansion
connection, they must form either the first or last panel in a chain. Expansion panels from the
500-40 range have both Expansion In and Expansion Out connectors, allowing them to be
connected in a chain. The PathFinder Lite configuration software includes full expansion
panel support (from version 4.12 onwards). This controls the sequence in which the panels
should be added to the configuration editor and the electrical interconnection sequence.
Obviously, the panels may be assembled into the control desk in any preferred positions,
cable lengths permitting. Two different cable types are required, Type A and Type B which
are detailed in section 4.4.4.
The following rules need to be observed when connecting expansion panels onto a system:
Ø
The standard series panels have only a single expansion port, used as “EXPANSION IN”
or “EXPANSION OUT”. Therefore, these panels must be connected on the beginning or
end of a chain only.
Ø
Standard control panels (500-3x series) used in expansion mode need the internal DIP
switch 1 set to “ON”. If the panels are supplied as part of a pre-configured system, this
will be carried out by Trilogy and the panels marked accordingly.
Ø
When a standard panel appears at the end of a chain, it must be connected using cable
type B (see 4.4.4).
Ø
The audio only operates on the first panel of the chain: if required, the microphone may
be removed from the second “standard” panel. Trilogy can supply a blank plug for the
mic fixing.
Ø
The maximum suggested cable length for interlinking cables is 10 metres.
A number of different arrangements are shown below; others are possible.