RES-3000-Focus
PA-0129A Rev. 1.0
June 18, 2010
Page 4 of 4
RES-3000-FocusAX
SecureMesh Radio Specifications:
•
IEEE Standard : IEEE
802.15.4
•
Power Output :
+30 dBm
•
Radio Sensitivity :
-99 dBm
•
RF Data rate :
250 kbps
•
Operating Frequency :
2.400-2.483 GHz
•
Network Topology :
Mesh
•
Modulation
:
O-QPSK
•
Physical Dimensions :
2.33” x 4.70”
•
Antenna
: Dipole,
3.5
dBi
Industry Canada and Federal Communication Commission Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
FCC Warning
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC and Industry Canada RF exposure limits for general population / uncontrolled
exposure, the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
