The rocker switch establishes the connection of the AC mains input to the front panel
power switch.
In the event that the main fuse needs changing, the AC mains connector must be
removed to access the fuse compartment.
CAUTION!
Replace fuses only with the same type to avoid possible damage!
[ 21 ]
REMOTE 10V DC input connector
The
Monolog
power amplifier will turn on if a
trigger
voltage
b4V and
+10V DC is applied to this connector with
AUTO power mode
10V DC
enabled. As
soon as the
trigger
voltage
is turned off, the
Monolog
power amplifier will shut
down.
[ 22 ]
REMOTE 10V DC output connector
This connector outputs a
10V DC trigger voltage
when a trigger signal is applied to
the
REMOTE 10V DC input connector
(
21
).
This feature allows to simultaneously turning on or off any number of
Monolog
power amplifiers from one trigger.
4. What if...
In this chapter you will find some useful tips on troubleshooting basic problems.
4.1 ... nothing happens?
- Is the unit plugged in correctly? -
Make sure that the AC mains cable is properly
seated and plugged in.
- Is the power outlet active or may a circuit breaker be tripped?
- Verify the circuit
breaker(s).
-
Is the main AC rocker switch on the rear panel in the ON position? -
Turn on the
main AC rocker switch.
- Is the internal fuse burned out? -
Replace the fuse with a new one of the same type.
If all else fails, send the unit for servicing.
4.2 ... there's power but no sound?
