2
Mono Power Amplifier
Dwarf
Dwarf
Dwarf
Dwarf II
II
II
II
TRIGON DWARF
II
- The David between the Mono Power Amplifier
The extreme skinny construction under the use of massive aluminium and structure vanished steel,
realizes a timeless and highquality design. Compared with TRIGON Suspension Absorber feet,
external disturbances of sensitive music signals will be reduced to a minimum.
The covered power cable
TRIGON Volt
and a very flat designed, but highly overdimensional
power pack, guarantee a signal adequate power supply. This complete and discreet built output stage,
which keeps short signal ways, fulfils all the complexity of musical expectations. The
DWARF II
gives - what music plays – with sensitivity and power to the speaker. It is the mediator between the
music and its emotions. The
DWARF II
unites precise technology, high operational safety and
operating comfort. A long distance signal way protected switch design supervises the amplifier
electronic. All operational conditions are switched with a frontage key through a relay and are
signalised through LED display.
DWARF II
can be switched on / off either manually, by a fed control
voltage or by the audio signal itself. For a pleasant realized operation it is recommended to place the
DWARF II
in immediate proximity to the speakers – not only during stereo operation, but also while
using multi–channelling.
We thank you very much for choosing
DWARF II
and wish you to enjoy music and technology.
.
DELIVERY CONDITIONS
Regularly the
DWARF II
are delivered in pairs in one box. Except the
DWARF II
you will also find
two main cables, an operation instruction and a guarantee card.
Please keep the original packaging, so you can send, in case of service or guarantee, safely and
avoid transportation damage.
INSTALLATION AND START-UP
Regularly Mono Power Amplifier is situated close to the speakers. With lower ohm output impedances
at the preamplifier the connection Cable should not be longer than 5 meters. Avoid direct sunlight, or
other heat sources and any kind of humidity. Keep the louvers absolutely free. Don’t put the amplifiers
on top of each other. There should be at least a minimum of 15 cm space between the
DWARF II
.
This measure is important, because the equipment could easily overheat. Turn the volume control at
the pre-amplifier to “Zero”. Connect one of the exits of the pre-amplifier with the Input
(5)
of the
DWARF II
.
Connect now the affiliated cable on the speaker
(9)
. Take care of the right poling
(pole); otherwise the
sound quality would suffer considerably.
Next you have to switch the main cable in the socket
(10)
, and connect it to the 230-volt mains.
Finally you turn the mains switch
(12)
in direction “
-
” and your amplifier
DWARF II
is ready for use.
When the
DWARF II
are connected to the mains the Status-LED
(2)
light up slightly and indicate the
Standby-mode.
3. OPERATION
3.1 Operating mode switch
By pressing this key all operating modes are switched. Please find them following:
Switch on - Switch on Audio Trigger - Switch on control voltage Trigger - Switch off
By each single depressing the next following switching level is adjusted. In the end it starts from the
beginning again, because the single operations modes are wired up like in a ring.
