TRIGEM 386X, Operation Manual

Page: 149 / 173

Internal Hard Disk Drive
If you are to mount the internal hard disk drive inside the main
system unit case, follow the steps below:
Remove
the cover from the main system unit, as described
above.
Remove mounting plate by unscrewing the hold down
screws.
Attach the hard disk drive to the mounting plate by
installing the four mounting screws through the bottom of
the plate into the bottom of the drive frame.
Replace the mounting plate onto the mounting frame by
sliding the plate into the two openings provided in the
mounting frame.
Replace the hold down screws.
Connect the hard disk drive controller cables to the drive.
Replace the main system unit cover.
N o t e
Your system has an on board IDE type HDC and if you
want to install the another type of HDD except IDE, you
must disable the on board IDE HDC using the Extended
Setup Program. See Chapter 2 for the detailed information
of it.
Expanding Your System 7-15