First cover the sink plug, open the tap and fill half of the sink, then
remove the plug, wipe the body, flange assembly, pipe connections with
paper towels, if there is leakage, please timely adjust and reinstall.
NOTE:
You must have access to an earth (grounded) wall socket.Any
additional socket should be fitted by a qualified electrician and properly
earthed(grounded).The disposer is fitted with a molded plug and cable.
1. Remove stopper from sink opening and run cold water.
2. Turn on wall switch to start disposer.
3. Slowly insert food waste into disposer. WARNING! Position stopper to
minimize possible ejection of material while grinding.
4. After grinding is complete, turn disposer off and run water for a few
seconds to flush drain line.
In the daily use of waste disposer, the following problems may occur. You can quickly solve them with the corresponding methods. Enjoy the
cleanliness and convenience brought by waste disposer:
Problem
Loud noises
Slow sewage discharge
Disposer water leakage
Possible Causes
Silverware, bottle cap or other
foreign object has fallen into the
Part pf the drain pipe is blocked
What To Do
Disconnect the power and water flow switch of the disposer first, and wait for
the disposer to stop working
，
check for an object lodged between the
turntable and the grind ring. Dislodge the object by moving the turntable with
a broom handle. Then remove the object.
A solution is to use a plumber or a special elastic rod tape to be cleared.
Check whether the rubber seal ring is installed in place and tighten the three
fastening screws on the buckle at the same time or replace the rubber seal
ring.
The sink and disposer flange are not connected in place;
the middle buckle screw is not tightened;rubber seal ring
is not installed in place
If the water leaks from the disposer outlet, the screws may
be loose or the water pipe may be broken
Check whether the outlet is normal, tighten the screws or replace the drain
pipe.
Foreign bodies fall in, block the machine and overheating
protection is enabled
Remove the power plug, check whether the plug and power cable are in
good condition, if any damage, please replace in time
If the motor still does not work, please contact the maintenance department
designated by the manufacturer.
11.CHECKING
OPERATING INSTRUCTIONS
TROUBLE SHOOTING TIPS
Motor stops when the
disposer is working
The motor does not work
The plug contact is poor
Remove the disposer plug
Check the grinding chamber, take out the foreign bodies with long clip or
tweezers
Insert the provided internal hex wrench into the base plate axis hole, rotate
clockwise and anti-clockwise 360°
Turn on the reset switch, connect the power, and the disposer can work
normally.
-4-
