1.Tape measure
2.Wire cutters
3.flashlight
4.wire strippers
5.flathead screwdriver
6.Phillips screwdriver
7.Adjustable pliers
PERSONAL INJURY
Wearing safety glasses is recommended
during the installation of the food waste disposer.
1. Loosen nut (1) at top of trap (4) with pipe wrench .
2. Loosen nut (2) at top of extension pipe. Remove extension pipe..
3. Loosen nut (3) at base of sink flange4.
4. Push sink flange up through sink hole and remove it
5. Clean sink flange area of any putty or other debris.
Remove flange mounting assembly from machine,turn mounting
assembly over,Use Hex wrench to loosen three mounting screws ,
Mounting assembly will now come apart.
Note:
the diameter of the disposer flange (GB) is 4.331in.
①
Ensure there is no debris around the sink drain hole, mount the upper
seal ring on the flange, and put the flange into the sink drain hole. You
may need to place a heavy object in the sink or hold it down by hand to
keep the flange in place (place a towel under the object to prevent
scratching).
②
Under the sink, mount the lower seal ring and upper buckle (flat side
up) on the flange in order.
③
Put the upper buckle of the lower seal ring in place, and mount the
middle buckle on the flange to hold the upper buckle.
④
When the upper and middle buckle of lower seal ting hold the sink
bottom tightly, tighten the three hex socket screws at the same time
until the mounting component is firmly installed on the sink, improper
operation will cause water leakage
Note:
the flange is designed with convex points. When the flange is
connected with the middle buckle, the convex points shall be stuck in the
middle of the middle buckle to prevent the equipment from falling due to
vibration.
2.HELPFUL TOOLS
3.DISCONNECT SINK DRAIN
CAUTION
4.SEPARATE COMPONENTS BEFORE CONNECTION OF
DISPOSER AND SINK
5.CONNECT FLANGE MOUNTING ASSEMBLY TO SINK
For safety and ease of garbage disposal installation, we recommends
the use of these helpful tools
-2-
1
2
3
4
5
6
7
