background image

5

5

This refrigerator has been built with the door hinges on the right. 

If you wish to change the opening direction, follow the instructions 

below:   

4.Changing the reversible door

4.Changing the reversible door

1. Remove the upper hinge cover(6) first.

2. Remove the two screws (1) that hold the upper hinge (5) (right side) 

    to the frame. Take away the upper hinge (5).

3. Lift the door and place it on a padded surface to prevent scratching it.

4. 

5. Remove the left front leg (4) and transfer it to the right side.

6. Remove the hole cover plate(7) to the right side.

7. Before placing this lower hinge(2), remove the bolt-pin (9) and 

    reverse the direction of the lower hinge(2). Then install the lower 

    hinge (2) onto the left side of the lower frame with two screws (8).

8. Insert the bolt-pin(9) to the lower hinge (2).

9. Set the door to its place making sure the door seat at the lower hinge(2).

10. 

11. Install  the upper hinge cover(6) on the upper hinge. 

Remove the two screws (8) that hold the lower hinge (2) and 

    then remove the hinges (2).

 

Hold the door in the closed position and secure the top hinges (5) 

      to the top frame of \the left side with the two screws (1).  

      Do not over tighten the two screws.  Only tighten until the top of 

      the door is levelled with the counter top.

6

6

4

4

8

8

3

3

9

9

2

2

4

4

8

8

3

3

7

7

2

2

9

9

7

7

1

1

6

6

5

5

1

1

6

6

5

5

7

7

The refrigerator should be cleaned and maintained once a month.

The power plug should always be disconnected from the 
power outlet before any cleaning or maintainance is carried out.

For cleaning, do not use hot water, petrol, alcohol, kerosene, 
washing powder, cleanser, alkaline detergent, acid or chemical 
clothes.  Never directly spray the refrigerator with water.  
This could cause rust or weaken the insulation.  

Wipe the inner, outer and accessories of the refrigerator only 
with luke warm water.  For heavier cleaning, use a small amount 
of washing detergent in luke warm water, then wipe down with
water and dry with a clean cloth.

Make sure that the rubber seals on the door are clean and not 
damaged. 

Avoid leaving oils and solubles on the plastic parts of the refrigerator.  
Try to wipe up as it is stain.  Not doing so could easily age the plastic.  
Bad odours can also occur if not cleaned regularly.

5.Maintenance 

5.Maintenance 

8

6. Troubleshooting

    

1. When the refrigerator does not work.
    Check if there is a power failure.
    Check if the power plug is plugged into the power outlet.
    Check that the fuse has not blown.

2. When the refrigerator is cooling excessively.
    The temperature control dial may be set too high.

3. When the refrigerator is not cooling sufficiently.
    

The door may not have been closed properly.

    The door gaskets may be damaged.
    

    The temperature control dial may not be set properly.

4. 
    Check that the drain pipe and the drain hose are not clogged.
    Check that the drain pan is housed properly.

5. When condensation form on the outside of the refrigerator.
    Condensation may form on the outside when the humidity is high
    such as during a wet season. This is the same result as the 
    condensation formed when chilled water is poured into a glass. 
    It does not, therefore, indicate a failure, wipe dry with a dry cloth.

6. When you hear a sound like water flowing.
    A sound like water flowing is the refrigerant flowing. 
    It does not Indicate a malfunction.

7. When the cabinet's side panel heats up.
    The  side panel of the cabinet will heat up when the door is opened 
    or closed frequently, when starting the unit and when the unit 
    operates in summer with high ambient outside temperature, In 
    such case, do not touch the panel, it results from the dissipation 
    of the heat from inside the cabinet, and it does not mean that 
    something is wrong with the refrigerator. 

You may have put something hot in.  

    Allow it to cool down.
    There is too much food in the refrigerator.
    

The door gasket/seals may be damaged.

    The refrigerator may not be well ventilated.  
    There maybe Insufficient clearance between the refrigerator 
    and surrounding walls. 

While defrosting, water overflows the refrigerator and onto the floor.

7.Technical specifications

7.Technical specifications

* For the detailed technical specifications, please refer to the nameplate 
  at the back of the refrigerator.

* Specifications are subject to change without prior notice.

Reviews: