3
LED PAR CAN Introduction
Unpacking:
Thank you for purchasing our products. Every unit has been thoroughly tested
and has been shipped in perfect operating condition. Carefully check the shipping carton for
damage that may have occurred during shipping. If the carton appears to be damaged, carefully
inspect your fixture for any damage and be sure all accessories necessary to operate the unit has
arrived intact. In the case damage has been found or parts are missing, save the carton and all
packing materials. In the event a fixture must be returned to the factory. It is important that the
fixture be returned in the original factory box and packing.
Introduction:
The unit is a DMX intelligent LED par can. This light can be used in a standalone
mode or connected in a Master/Slave configuration. The unit can also be controlled via DMX
controller. This light has four operating modes: Sound Active mode, stand alone mode,
Master/Slave and DMX control mode.
AC Power:
This fixture has an auto-switching power supply that can accommodate a wide range
of input voltages. The only thing necessary to do before powering on the unit is to make sure the
line voltage you are applying is within the range of accepted voltages. This fixture will
accommodate between 90V and 240V AC. All fixtures must be powered directly off a switched
circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit. Even if the rheostat or
dimmer channel is used solely for a 0-100% switch.
Safety Instructions:
• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture
• Do not spill water or other liquids into or on to your unit.
• Be sure that the local power outlet match that of the required volt-
age for your unit.
• Do not attempt to operate this unit if the power cord has been
frayed or broken. Do not attempt to remove or break off the ground
prong from the electrical cord. This prong is used to reduce the risk
of electrical shock and fire in case of an internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no users
serviceable parts inside.
• Never operate this unit when its cover is removed.
• Never plug this unit in to a dimmer pack
•Always be sure to mount this unit in an area that will allow proper
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance of this
product?
