Tribute IMALA, Owner'S Handbook Manual

Page: 32 / 62

31
The toilet is made up of two parts:
a permanently fixed toilet and a waste holding tank
that is accessible from the outside.
The removable waste holding tank is located under
the toilet and can be removed via an access door on
the outside of the motorhome.
Preparing For Use
• Remove the waste holding tank by pulling
the safety catch upwards.
• Pull the waste holding tank outward
towards the stop. Tip it slightly and take
out the tank completely.
• Place the tank upright and turn the
emptying spout upwards.
• Remove the cap (which has a measuring
cup inside) and pour into the tank the
required quantity of Thetford toilet fluid.
Add approximately 2 litres of water
(enough to cover the bottom of the tank).
Screw the measuring cap back onto the
emptying spout and turn the spout back
to its original position.
• Slide the holding tank back into its original
position via the access door.
• Make sure that the waste holding tank is
secured with the safety catch. Shut the
access door and lock it.
In Use
• Rotate the toilet bowl to the desired position.
• The toilet may be used with the blade valve
open or closed. To open the valve pull the
valve handle under the bowl towards you.
If the toilet is being used with the blade
valve closed run some water into the
bowl by pressing the ‘FLUSH’ button once.
The toilet is now ready for use.
• After use, open the blade valve (if it was
closed) and press the ‘FLUSH’ button.
Close the blade valve after flushing.
Emptying The Waste Holding Tank
The waste holding tank must be emptied, at
the latest, when the warning lamp is lit but it is
advisable to empty the tank earlier if possible.
Do not allow the holding tank to become
too full.
• Ensure that the valve blade is closed.
Open the access door outside the vehicle.
Pull the safety catch upwards and remove
the waste holding tank.
• Carry the tank by the handles to a normal
toilet or to a legal waste disposal site.
Place the waste holding tank upright
and turn the emptying spout upwards.
• Remove the emptying spout cap. Hold the
waste holding tank by the upper handle
nearest to the emptying spout. Hold the rear
handle with your other hand so that you can
operate the vent plunger with your thumb.
Keep the vent plunger pressed to ensure
that the tank is emptied without splashing.
Please note that the vent plunger should
only be pressed when the emptying spout is
pointing downward.
After emptying, flush the tank and clean
the blade valve thoroughly with water.
Replace the spout cap and slide the
waste holding tank back into the
toilet and close the door.
Owners Handbook
Thetford Cassette Toilet
Thetford Cassette Toilet