Tribest MILL-1, Operation Manual, Page: 9 / 20

9
START-UP
Please first read through the section “Before First Use” (p. 7) and “Important Safeguards”
(p. 6)!
Be absolutely sure to remove the transport guard before first use! You can remove the transport guard
by removing the four brass screws (figure 1) on the funnel plate and lifting up the funnel (figure 2).
Completely remove the three red screws with a cross-slotted screw driver (figure 3).
Check that the foam rubber gasket is properly seated around the hole in the top grindstone (figure 4).
You can now return the funnel to its previous position and secure it with the brass screws.
Milling
Once connected to a power supply, your Tribest Grain Mill is ready for use.
Place a bowl under the flour outlet and adjust the fineness (figure 5). Then fill the funnel with grain
and turn on the mill.
Figure 1 Remove the four
bronze screws with the
enclosed Allen wrench.
Figure 2 Lift the funnel Figure 3 Remove the red
transport screws
Figure 5 Set the fineness: forward
for fine, back for coarse
Figure 4 Make sure the foam
rubber gasket is properly seated
(arrow). Now return the funnel to
its previous position and secure
it with the brass screws
Funnel lid
Funnel
Brass screws
Adjusting lever
Flour outlet
On/Off Switch