Rear Panel Overview
7
1
2
3 7
10
4 6 8
9
5
1. LAN
Ethernet Connection point from Router allowing Internet
2. RS-232
Used to connect PC, Laptop or notebook to the Matrix for programing, it requires a
D-SUB 9 pin cable. (Not supplied).
3. All IR output
“IR Emitter” 3.5mm stereo jack socket, “IR” signals are emitted across all “Sources”.
NOTE if more than 1 SKY Receiver is used a Directional “IR” Emitter is required. “IR
Emitter” included.
4. All IR Inputs
IR Digital Eye 3.5mm Stereo jack socket IR signal receiving from the remote control of
this device and the display equipment’s.
5. Mini USB
Used for Software firmware update only.
6. IR IN 1-4
The digital eye receiver is connected to the 3.5mm Jack Socket labelled IR IN to send
control signals back from the matrix position to the TV Sink. A dedicated emitter is
required at the sink device (TV).
7. IR Out 1-4
The emitters are connected to the 3.5mm Jack Sockets to control the HDMI source
from the selected zone.
8. CAT5e/6/7 Outputs 1-4
RJ45 CAT5e/6/7 outputs, connect CAT cables then connected to receivers at all
locations. EIA/TIA 568B wiring method required.
9. HDMI Inputs 1-4
HDMI Inputs from “Source equipment” such as Blu-ray player, SKY / Freesat HD
Receivers. A maximum 4 Sources can be connected and controlled independently.
10. Mains Adaptor 24V DC and PoE 24V
PoE voltage is carried across the CAT5e/6/7 cable, designed to power the Receivers
