![background image](http://html1.mh-extra.com/html/triax/ccs-2-1002/ccs-2-1002_assembly-instructions-manual_1160864014.webp)
- 14 -
CCS-2 1002
5
P
rogramming
5.1 P
rePar ation
• Test the software versions of the head-end station and the cassette and up-
date them if necessary.
The current software versions can be found on the website "
www.triax.com
".
• Connect the test receiver to the HF output or the test output of the head-end
station.
• Set the output channel / output frequency of the cassette (page 20) and adjust
the TV test receiver to this channel / frequency.
• Switch on the channel strip (modulator) if necessary (page 20).
• Balance the output levels of the channel strips "
A
" and "
B
" if the difference
in level is
≥
1 dB (page 20).
5.2 n
otes
on
level
set ting
• Measure the output levels of the other cassettes and tune them to a uniform
output level using the appropriate level controls or software dependent on
the head-end station used. Please regard the assembly instructions of the
respective head-end station.
—> In order to prevent interference within the head-end station and the
cable system, the output level of the cassette must be lowered by
4 dB compared to the analogous level (PAL).