PRESTIGE Stand
Leg Kit Instructions
4
6. Place the long side of the Left and Right
Brackets on the bottom of the Wall Frame Long
Struts as shown in Figure 3. The short side of
each bracket should be flush with the bottom of
each strut. Install two T-Bolts and nuts through
each bracket and into the channels of the struts.
Tightening the nut will cause the bolt to turn
clockwise 90°. Tighten the nut and confirm that
the T-Bolt rotated 90° and is fully engaging the
channel of the strut.
7. Install two Leveling Feet on the bottom of each
Leg Strut. The bottom of the Leg Strut is the
side that has the outer lip of the threaded sleeve
exposed. Hand tighten only, since the feet will
need to be adjusted later to level the stand.
8. Install end caps on the ends of each Leg Strut.
Note that two end caps are supplied with the
Leg Kit and two end caps were leftover from
the Wall Stand Kit.
9. Install Gussets on the top of each Leg Strut as
shown in Figure 4. The edge of the Gusset
should be 3” from the rear of the Leg Strut.
Install a T-Bolt and nut through each Gusset and
into the channel of the Leg Strut. Tightening
the nut will cause the bolt to turn clockwise 90°.
Tighten the nut and confirm that the T-Bolt
rotated 90° and is fully engaging the channel of
the strut.
The position of the Gusset on the Leg Strut is
critical to the stability of the Stand.
Improper positioning could lead to tipping
over of the Stand and Boiler resulting in seri-
ous injury or substantial property damage.
10. Attach each Leg Strut to the bottom of the Wall
Frame assembly as shown in Figure 4. Install a
T-Bolt and nut through each Gusset and into the
channel of the Long Strut of the Wall Frame.
Tightening the nut will cause the bolt to turn
clockwise 90°. Tighten the nut and confirm that
the T-Bolt rotated 90° and is fully engaging the
channel of the strut.
11. Install two T-Bolts and nuts through each Left
and Right Bracket and into the channel of each
Leg Strut. Tightening the nut will cause the bolt
to turn clockwise 90°. Tighten the nut and con-
firm that the T-Bolt rotated 90° and is fully
engaging the channel of the strut.
WARNING
Leg Struts
Leveling Feet (Typ)
3”
Gusset
Assembly
Fig. 4: Leg Assembly
Wall Frame
Assembly
Leg Kit
Assembly
Fig. 5: Complete Assembly
