PRESTIGE Stand
Leg Kit Instructions
Leg Kit Assembly
1. The installer must reference the kit instructions
and have completed the assembly of the Wall
Frame Kit PSSTND02. The Leg Kit will attach
to the Wall Frame Assembly to produce a com-
plete Stand.
The installer does not have to mount the Wall
Frame to a stud wall when using the Leg Kit
components.
2. Layout all components as shown in Figure 1
and confirm that nothing is missing.
3. Place a Gusset on each end of the Short Strut as
shown in Figure 2. The edge of each Gusset
should be flush with the end of the strut. The
alignment tab will protrude past the end of the
strut.
4. Thread a nut onto the end of a T-Bolt as shown
in Figure 2. Install a T-Bolt and nut through the
opening in each Gusset and into the channel of
the strut. Tightening the nut will cause the bolt
to turn clockwise 90°. Tighten the nut and con-
firm that the T-Bolt rotated 90° and is fully
engaging the channel of the strut.
For ease of installation, it is best to lower the
T-Bolt and nut down in to the strut as shown
in Figure 2. Note that the end of each T-Bolt
has a mark to indicate the orientation of the
bolt head. This mark can be used to confirm
that the T-Bolt has rotated the entire 90°.
Proper installation and tightening of the T-
Bolts are critical to maintain the integrity of
the completed stand. All fasteners must be
torqued to a minimum of 25 ft-lbs. Improper
installation of the T-Bolts could lead to fail-
ure and result in serious injury or substantial
property damage.
5. Measure and mark each Long Strut 6” from the
bottom. Position the Short Strut between the
Long Struts with the Gussets oriented down-
ward as shown in Figure 3. The bottom of the
Short Strut should be aligned with the marks on
the Long Struts. Install a T-Bolt and nut
through each Gusset and into the channel of the
Long Strut. Tightening the nut will cause the
bolt to turn clockwise 90°. Tighten the nut and
confirm that the T-Bolt rotated 90° and is fully
engaging the channel of the strut.
NOTICE
WARNING
NOTICE
3
T-Bolt
Gusset
Short
Strut
Fig. 2: Gusset Assembly
6ʼʼ
RH
Bracket
T-Bolt
(Typ)
Gusset
Assembly
Short Strut
Fig. 3: Bracket Location and Assembly
