Triangle Engineering Tales, User Manual

Page: 20 / 24

20
EN
Powering ON
Powering ON should be carried out as follows :
- Check once again that all connections are correct and that the volume button of your amplifier is
at minimum.
- Connect the power plug.
- Switch the ON /OFF switch to ON, the blue LED on the front panel lights up.
- Adjust the volume, frequency and phase buttons (see Settings).
- The standby is done automatically if no signal is received for 15 minutes, the LED on the front
panel becomes red.
Note : Cut off the power supply of the subwoofer by using the power switch when it is not in use
for several days.
Positionning and settings
Position your subwoofer in the forward listening zone (if possible between the two main speakers)
for a better sound resolution.
This subwoofer can be used with any type of loudspeakers.
The ideal setting should correspond to a realistic reproduction of the bass and be adjusted the best
possible with your main loudspeakers. You should not «feel» the subwoofer, the bass should seem
to come from the main speakers.
The phase inversion switch can be used to to reach the best result possible. This switch is used to
inverse the phase of the sound signals coming from the subwoofer. Depending on the placement
of the subwoofer in the room in relation to the main speakers, inverting the subwoofer phase can
lead to a better coherence of the system’s global response in the bass frequencies.
We recommend you to carry out various tests until finding the setting which suits you the best. Use
a recording you know well and study the result according to your taste and expectations.