pg. 4
- Triad InCeiling R-Series Quick Start Guide
Triad InCeiling R-Series Quick Start Guide -
pg. 5
RETROFIT INSTALLATION AND WIRING
Use a stud finder to locate the two joists flanking the location in
which you wish to install the speaker.
On the back of the speaker, you’ll
find a pair of push-type speaker
wire connectors.
NEW CONSTRUCTION INSTALLATION
cont.
RETROFIT INSTALLATION AND WIRING
cont.
3
1
2
Press the connector head
down, exposing a hole.
Insert speaker wire into the
hole, then release the head
to lock it onto the wire.
Fasten each NCB flange to the
joist with two screws through
attachment holes.
Note
: NCB R5, R6, and R8
Bracket wings are scored so that
you can easily break them off to
shorten them if they are too long.
scores
flange
Using the enclosed hole
cutout template as a guide,
mark the outline on the
ceiling with pencil.
3
4
6
5
Slowly cut along the
outlined mark with a
drywall knife/saw, trying
not to chip out the
drywall excessively.
To keep polarity correct, connect the amplifier’s + (positive) channel to
speaker’s + (positive) channel and the amplifier’s - (negative) channel
to the speaker’s - (negative) channel. To avoid shorts, keep stray
strands clear of adjoining connectors.
For R28DT only
The R28DT has has four
binding posts for its
dual-voice-coil woofer and
two tweeters. Connect the
two left channel wires to one
pair of binding posts and the
two right channel wires to the
other pair of binding posts.
Left channel
Right
channel
Ins
talla
tion
Ins
talla
tion
