Page 18
•
Receiver will now be set to match your transmitter, and will be turned off.
•
Check for a successful match by turning receiver back on and pressing
a “continuous” transmitter button. The receiver light will turn on. If you are
not planning to use the unit now, turn the receiver off after testing.
If the transmitter does not operate the new receiver, try the procedure again. If
you are still having trouble please call our Customer Service Department.
Special note for Classic 70 G2 EXP or Trashbreaker G2 EXP. When adding a
receiver for dogs 1 – 3, use the button that matches the strap color and place the
dog selection switch in the UP position. When adding a receiver for dogs 4 – 6,
use the button inside the colored circle that matches the strap color and place the
dog selection switch in the DOWN position.
Tone or Buzz Option. You can use your tone or buzz button instead of your
continuous button in the above procedure if you prefer.
Moving a Matched Receiver to a Different System. An EXP receiver will
remain matched to its transmitter until matched to a different compatible
transmitter by following the “Adding a Receiver” steps.
Lost Collar Replacement. A new EXP receiver may also be used to replace a lost
receiver of compatible models. Follow the instructions above.
Backwards Compatibility. In some cases an older Field & Pro Series G2 or Sport
G2 receiver or transmitter can be used with a G2 EXP or Sport G3 transmitter or
receiver, and in other cases they will not be compatible. If you want to combine
equipment from these series, please call our Customer Service Department for advice.
Page 17
Collar Straps. A different colored strap should be used on each dog so you know
which dog will receive stimulation when you press a button. The strap colors
match the colors on the dog selection switch. Your single-dog G2 EXP or Sport
G3 system includes two additional collar straps so you can expand any G2 EXP or
Sport G3 system to train up to three dogs.
The Classic 70 G2 EXP or Trashbreaker G2 EXP can train up to 6 dogs. If you
are adding receivers 4 – 6 to these models, a package of orange, green and yellow
straps is available from Tri-Tronics or your favorite dealer.
You can also use any collar strap of your choice that fits through the belt loops of
the receiver.
Adding a Receiver. To add an additional receiver to your G2 EXP or Sport G3
system, follow these steps.
NOTE: Two additional colored straps were included with your original purchase.
Please read all steps before starting.
•
Install strap of the desired color on the new receiver and charge new receiver
for two hours.
•
Set transmitter dog selection switch to the color of the strap.
•
Set transmitter intensity dial to a number, not a letter.
•
Turn the receiver on.
•
Press and hold receiver on/off button, then press and hold a “continuous”
transmitter button. Hold both buttons down for about 5 seconds – until you
hear two quick beeps (ignore the long beep that sounds right away). Release
both buttons.
Summary of Contents for Field G3 series
Page 1: ......