Tri-Tronics Beeper, Owner'S Manual

Page: 7 / 11

Beeper Power Switch
The Beeper must be turned on to
operate. The power switch is on the rear
face of the Beeper (opposite from the
Beeper light). Press this switch to turn
the Beeper on. You will hear two
confirming tones, and the Beeper light
will begin flashing. The Beeper will begin
beeping immediately, and the modes will
be those that you have already set. To
save battery life, turn Beeper power off
after use.
Beeper Control Button
• Upland G2: The rubber-covered
button in the center of the back side
of the transmitter.
• Sport
®
65 BPR G2: The small orange
button.
• Any G2 Field or Pro Series model
other than the Upland G2: Any
button, including the “tone” button,
provided the intensity dial is set
on “A.”
Controlling the Beeper
with the Transmitter
(Upland G2, Sport
®
65 BPR G2 and all
other G2 Field or Pro Series models.)
Pressing the Beeper button activates or
deactivates the Beeper from a distance.
The distance is the full range of your
remote trainer (one-half or one-mile
depending on model). Three tones con-
firm that the Beeper is activated, and
three different tones confirm that it is
deactivated.
Note that to turn the Beeper on or off
remotely:
• The training collar must be activated
(see your Remote Trainer Owner's
Guide).
• The transmitter intensity dial must
not be set on “N” or “T.”
• If you are using a G2 Field or Pro
Series G2 model other than the
Upland G2, your intensity dial must
be set on “A.”
• The Beeper power must be on.