14
TRI TOOL INC.
92-1783 Orig. 161006
2. Make sure that the cutting edge of the Beveling Tool Bit is along the Radial
Centerline of the Headstock, advance into the cut.
5.4 BeVeL/fACe TOOL BLOCk
The Bevel/Face Tool Block is designed with a 37.5° angle so that a Straight Tool
Bit may be used for beveling, refer to Fig. 6. When the 37.5° Facing Tool Bit is
used the Tool Bit height is adjustable.
Refer to Fig. 7 for a Tool Block with a Facing Tool Bit.
Install either the Compound Bevel Tool Bits, or J-Bevel Tool Bits, in this Tool
Block.
Rotation
Hex Wrench
Tool Bit
Tool Block
Set Screw
1. Make that the Tool Bit(s) sit flush against the Slot and then tighten the Locking
Set Screws. Refer to Fig. 5.
figure: 5. Tool Bit Position in slot
