14
-
Press the button DAY (9) and select the current day of the week with the b e – (8).
-
Press the button CLOCK (10) and select the actual hour with the b e – (8).
-
Press the button MIN (11) and select the actual minutes with the b e – (8).
-
After 10 seconds the display stops flashing and date and hour are set.
CAUTION: unplug unit, or bring the general ON/OFF (4) on “0”, will make the data be lost.
WEEKLY TIMER SETTING
In AUTO mode the convector switches on and off in the times of the week set by the user. To set these times:
-
Press the power button (2) on product or remote control.
-
Press the button WEEK/TIME (12).
-
Press the button DAY (9) and select the day of the week you want to set with the b e – (8).
-
In this day, you can set the hour of appliance switch on; press CLOCK (10) and select the hour with the
b e – (8), then press MIN (11) and select the minutes with the b e – (8).
-
Premere il tasto SET UP (13) ed impostare allo stesso modo l’ora di spegnimento.
-
CAUTION: the switch off time must be after the switch on time.
-
Make this operation for all the days of the week.
INSTALLATION AND ASSEMBLY
The assembly and installation must be done by following a few instructions.
-
The appliance must be placed high enough to be out of the reach of children (at least 180cm from the floor).
-
The appliance must be placed at a minimum distance of 50 cm from the sidewalls.
-
Do not mount on a vibrating surface. The device is not waterproof. Do not mount outdoor, prevent leakage,
humidity and splashes of water. Do not install in rooms smaller than 4m
2
.
-
Make sure that the ventilation holes are not obstructed, even partially.
CAUTION! The plugs and screws supplied are only suitable for
mounting on masonry walls. If you decide to install the unit on another
type of wall (plasterboard or other), buy appropriate anchors.
-
By using a yardstick, measure the distance between the two back shapes
on back of unit (46 cm).
-
Take the product and place it on the wall in the desired location. Mark on
the wall the positions corresponding to the two back-shapes. Check that
the marks are aligned at 46 cm from each other. Drill two holes (diameter
6mm) in the wall and insert the dowels into the holes.
-
Use a screwdriver to insert the screws into the anchors and tighten to
lock the pieces themselves, leaving the screws about 1 inch off the wall.
-
Set the product to the wall by inserting screws inside the shapes.
-
Once the screws are inserted, move the unit to the left until it locks in position firmly.
CLEANING
Unplug the power cord from the electrical outlet and allow the unit to cool down before cleaning.
-
Do not immerse the unit in water. In any case, avoid splashing of water or other liquids reaching the
appliance. Regularly clean the ventilation slot (7) on the back of the unit and the air outlet grille (1) to
prevent the dirt from clogging the airflow.
-
Do not clean the unit with a sponge or abrasive detergents.
TECHNICAL FEATURES
•
Power supply: AC 230V
~
50/60Hz, power: 2000W
•
Ceramic Heating elements
•
Wall-mounting
•
Digital display, Remote control
•
Safety device against overheating
