Trevi Therm and Trevi Outline
To remove the Outline handles, the cover slip
(4d or 5d) should be prised up by inserting a
small screw driver in the recess as shown. Care
should be taken not to scratch the handle while
doing this and it is advisable to wrap a piece of
masking tape or similar around the screw driver
as shown.
Unscrew screw (8b) and slide the handle off.
The handle carrier can then be removed.
To replace the handle slide onto handle carrier
(10) ensuring the key inside the handle engages
with the keyway in the carrier (10).
HANDLE FIXATION/REMOVAL
12
Figure 17
Temperature over-ride button
The Trevi Therm and the Trevi Outline
Thermostat (but not the Trevi Traditional) are
fitted with a temperature over-ride button.
Normally this is pre-set to limit the temperature
to 40ºC. However, higher temperatures may
be obtained by pressing the button and rotat-
ing the temperature handle further.
The Trevi Therm button slides outwards and the
Trevi Outline Thermostat button pivots inwards
as shown.
trevi showers.qxd 04/12/03 13:21 Page 13
