Trevi Traditional
The volume and temperature control handles
are not pre-fitted but are supplied packed
with the valve.
The Traditional valve should be fitted only in
position 3 as shown as in Figure 8
1. Push the volume control handle insert (10a)
into the volume control handle (6a) and
push this assembly on the drive shaft (15).
2
Secure with the screw (8b) and finally push
the cap (5) into place
For correct operation the temperature handle
must be fitted as follows
1
The temperature adjustment carrier is fitted
as below.
2. To fit the temperature handle (7a), push it
onto the temperature adjustment carrier
(21) with the lever at the 4 o’clock position.
The wide key on the inside of the lever
should engage with the key way on the
temperature adjustment carrier (21).
3. Secure the lever with the screw (8)
4. When the lever is moved to the 6 o’clock
position the water temperature should be
approximately 35ºC
5. To increase the temperature, move the
handle anticlockwise. See Figure 16
Figure 14
Figure 15
Figure 16
HANDLE FIXATION/REMOVAL
11
Figure 13 Fitting Trevi Traditional
volume control handle
trevi showers.qxd 04/12/03 13:21 Page 12
