6
Start Operation
Battery
This camera uses the original packaged built-in rechargeable 3.7V lithium battery.
Battery disassembly is prohibited.
Battery Recharge
Before you turn off the camera, then connect the camera with the USB cable
attached to the USB port of your computer. Once you have connected to your
computer, the camera automatically goes into battery charging, the battery level
indicator will Flash. After charging the battery level indicator will stop flashing. The
charging time is around 1 hour and a half.
Memory card installation
Following instructions by the card slot, it is plug the Micro SD memory card into
the card slot with metal pins inwards.
To take the memory card out, please press the Micro SD card downward and take
it out.
────────────────────────────────────
Attention:
Please disconnect power supply of the camera before replacing the
memory card;
Keep a correct direction to plug the card in. Gently plug the card to
void card or camera parts damaged. In case of fail to plug in, check it
is in a correct direction to plug in;
Please format the memory card before the first time of use, using a
card having been used on other cameras.
────────────────────────────────────
Power-on
Press and hold power key for 2 seconds and release it for power-on of the
camera.
Mode switchover
After power-on, the camera enters the default mode of video recording at a default
size of Lo. In video recording mode at Lo size, click MODE key to switch the size
to HI; in video recording mode at HI size, click MODE key to enter capture mode
at Lo size, and in capture mode at Lo size, click MODE key to return to video
recording mode at Lo size.