Add sand.
Before uncoiling the wall, make sure the pre-punched holes for the
skimmer and pump return are at the top and facing the planned lo-
cation of your filter.
Begin inserting the wall into the bottom wall tracks in the middle of
a joiner plate. At first, the wall is kept in place with one or two stakes
and strings (or extra persons). One person uncoils the wall on a
beam or a plank, while a second person inserts it in the bottom wall
tracks. Do not uncoil more than 3 m (10') of wall before you install
a support bar or stake and string to reinforce the structure.
Once the wall is completely uncoiled, you may find that it is too long
or that both ends do not meet by a few centimetres. If such is the
case, adjust tracks and joiner plates until wall holes line up. If this
does not work, roll up the wall again, check measurements as per
Illustrition 1.1, adjust tracks and plates, if applicable, and uncoil the
wall again. If the spread is too wide, measure the wall and check it
against the chart below.
Join the ends of the walls by orienting folds outward to hide the ex-
clamation icon. (Illustration 8.1)
Note: If the wall is attached properly, you should no longer see
the exclamation icon. If you can always see the icon, you must
reverse the overlap.
Insert bolts and nuts in every hole and tighten with wrench (screw
head on water side of wall). Tape over screw heads with duck tape.
WALL INSTALLATION
5
SAND
STAKE AND STRING
PLANKS
BOTTOM PLATE
End
Illustration 5.1
D
o
not
u
se
i
m
pac
t
gu
n
f
o
r wall
s
cr
e
w
s
.
Mi
n
i
m
u
m
to
rqu
e
f
o
rc
e
o
f 6
0
i
n
ch
p
o
u
n
d
s
to
m
axi
m
u
m
o
f
85
i
n
ch p
o
u
n
d
s
.
Ou
ts
id
e
o
f p
oo
l
I
ns
id
e
o
f p
oo
l
F
o
ld
F
o
ld
BOLT
E
nd
S
tart
NUT
I
ns
id
e
o
f p
oo
l
Ou
ts
id
e
o
f p
oo
l
!
IMPORTANT! Installing the wall joint in non-compliance with the specifications dictated by the manufacturer will void the warranty.
A faulty installation will cause the wall/joint to split which could result in serious and/or fatal injuries!
