TEM-1800
7298
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel,fax:+48 58 56 300 80
7
Before first use
WARNING! DANGER OF INJURY! Switch the device off and pull the plug out of the
mains socket before carrying out any work in the device.
Placing a whisk
NOTE: Use only whisks conform the specified diameter.
Screw the whisk with thread (M14) as far as possible in the tool
Tighten the whisk properly with an open-end wrench.
First use
The mains voltage at the mains socket must match that shown on the rating plate on
the device.
Using
Improper use may damage the instrument. Observe therefore these
instructions:
Use a tool up to the specified diameter.
Load the tool in such a way that the speed would not drop
considerably or that it would stop.
Check if the data on the rating plate correspond with the actual mains
voltage.
Switching on and off
To switch on the tool, press and hold the on/off switch (1).
If you release the on/off switch, the tool will be switched off.
Switch locking mechanism
You can lock the on/off switch by pressing the on/off switch (1) and then button (2).
The switch lock can be released by briefly pressing the on/off switch.
Infinitely adjustable speed setting
Two rpm ranges can be pre-selected with the speed selector switch (4):
Gear 1 180-400 /min
Gear 2 300-700 /min
The necessary speed depends on the type of the material mixed and it is
