TID-13/1050
4659
“EGA" Spółka z o.o. Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel,fax:+48 58 56 300 80 www,egatools.com
21
Before performing any adjustment, make sure that the drill is turned off and plug is
disconnected from the power outlet.
Fixing drill
Drill is equipped with Key less chuck allows for quick and easy replacement of the drill.
1.In order to open the jaw with one hand hold the rear ring and the second turn to the left
side of the front ring (Fig.2)
2.Open the chuck jaws enough that you can
not put in the required drill. The jaws should
securely tighten the smooth surface of the drill.
3.To tighten the drill holder, turn in the opposite
direction the front ring holder.
Operation
Switching on and off
The tool should be in good condition.
1.Plug the cable into a power outlet.
2.Set the desired direction of rotation of the handle by moving
the lever to the direction of rotation to the left or right. Then, to
get started, press the button (Fig.3).
3.To disable the tool, release the power button.
4.If you need to work in continuous mode, press the lock
button (Fig.3) when fully depressed the button switch.
5.To release the lock press again and then release the power button.
Reversing lever
1.Lever change the direction of rotation ( Fig.4) is used to
determine the direction of rotation of the chuck.
2.To set the rotation to the right, release the power button
and then move the lever to the right (setting R). To set the
reverse rotation, the lever must move to the left (position L).
3.While changing the setting lever switch button must be
released and drill motor can not rotate.
Fig.2
Fig.3
Fig.4
