BRIDGED CONFIGURATION
1
AMPLIFIER FUNCTIONS
This should be connected to the subwoofer(s). Please use speaker cables
with a minimum thickness of 12 AWG. Do not short the speaker wires to each
other or to the chassis as this may damage the amplifier. Ensure that the
minimum impedance is ONE OHM. The amplifier has only one channel. Both
positive terminals and both negative terminals are connected to the same
channel.
This should be connected directly to the battery. Please use power wiring
with a minimum thickness of 4 AWG. Be sure to install an in-line fuse within
twelve inches of the battery.
This should be connected to the remote lead of your source unit. Please use
primary wire with a minimum thickness of 22 AWG. If your application uses
two or more amplifiers it may be necessary to use a relay for the remote lead.
This should be connected to an unpainted metal part of the vehicle chassis.
Please use wiring with a minimum thickness of 4 AWG. The ground wire
should be as short as possible and should be at least as thick as the power
wiring.
The gain knob is NOT a volume control. The gain is adjustable to allow
connection of this amplifier to source units with output levels from 200mV to
5V.
This control overrides the gain knob on the amplifier chassis.
This should be connected to the RCA audio output from your source unit.
Please use high quality twisted-pair RCA cables. Keep RCA cables away
from power cables to prevent noise.
