TRENDware ProXpress TE100-S55, User Manual

Page: 44 / 57

44
Port Status LEDs
TE100-S55 is equipped with six Status LEDs which reflect the
status of each port.
As you connect a network cable to the TE100-S55, it will auto-
detect the type of cable and the corresponding
10/100 LED will
light up. Likewise, depending on the port connection, the
DUPLEX LED will light up to indicate its status of full or half
duplex signaling.
When a port connection is active, the LINK LED will light up to
indicate its operative state. Also, as activities occur on the
network, the
RX or TX LED will light up to indicate its
transmission or reception of data.
When multiple packets are delivered at the same time, a collision
will occur and the
COL LED will light up. Although collisions
are normal, if there’s too much, you should consider rearranging
the workgroups or optimize the network for reduced traffic.
Port LED Status Port State Action
10/100
On
Off 100Mbps
10 Mbps
Duplex
On
Off Full Duplex
Half Duplex
Link
On
Off Port Connection Normal
Port Connection Inactive
Check connections on
this cable segment
Tx or RX Off
Blinking
On No packet traffic
TD or RD Active
Heavy packet traffic
Check if consistently
heavy
Col Off
Blinking
On
No collision
Collision Active
Jabber, serious problem Normal
Normal
Check this segment