TW-H6W1IR ISDN Remote Router
58
Configuration
and
Management
??
Remote Name
– Name for the remote network that the TW-
H6W1IR is being set up to connect with.
??
Direction –
dial-[
In
], dial-[
Out
], or [
Both
]. This field defines
whether the router on the other network will dial-[
In
] to the TW-
H6W1IR to establish a connection, the TW-H6W1IR will dial-
[
Out
] to the other network, or a connection can be established
[
Both
] ways.
When this is set to
In
, the TW-H6W1IR will only establish a
connection with the other network by receiving calls on the ISDN
port specified in the
Interface
field below. Also, the incoming calls
will be subject to the
Name
,
Password
and
Rem CLID
fields in the
Incoming
section below.
When this is set to
Out
, the router will only make calls on the ISDN
interface specified in the
Interface
field below. Also, the outgoing
calls will be subject to the
Name
,
Password
and
Phone Number
fields in the
Outgoing
section below.
When set to
Both
, the
dial in
and
dial out
conditions described
above will both be observed.
??
Interface
– ISDN Link 1 [ISDN L1] or ISDN Link 2 [ISDN L2].
This field is used to assign a remote network to a logical (virtual)
interface called a virtual circuit. More than one remote network can
be configured to use the same interface, but they cannot be
connected at the same time. Thus, if you wish to have two WAN
connections operate simultaneously, make sure they are configured
on different interfaces. On the other hand, if you have two dial-out
remote network profiles but wish to keep one line always open for
dial-in users, make sure the two dial-out profiles use the same
interface. In this case, the two profiles will share the same interface;
Summary of Contents for TW-H6W1IR
Page 2: ......
Page 8: ......
Page 154: ...TW H6W1IR ISDN Remote Router 146 Appendix C IP Protocol and Port Numbers SNMP Trap 162...