TRENDnet TEW-826DAP, User Manual, Page: 51 / 72

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
48
Time and Date Settings
Management > Time and Date Settings
There are two ways to set the access point’s date and time: NTP (Network Time Protocol,
based on time servers) or manually.
Note: It is important that the time is configured correctly before setting any schedules.
Automatically set using NTP:
1. Log into your management page (see “ Access the management page ” on page
8).
2. Click on the Management tab and click Time and Date Settings.
3. Next to Time Zone, click the drop-down list to select your time zone.
Daylight Saving Time:
Management > Time and Date Settings
When using NTP or manual configuration, you may also configure Daylight Saving
feature.

Enable: Check option to enable daylight savings

Daylight Saving Offset: Select the offset amount for daylight savings to
apply

Start/End Time: Configure the start and end time of daylight savings.
NTP Settings:
Management > Time and Date Settings
Review the settings below and click Save to save settings.

Enable: Check option to enable NTP feature

NTP Server: Select the NTP server to use

NTP synchronization: Enter the time of when the access point will
continue to check for NTP updates.
Date and Time Settings (manually set):
Management > Time and Date Settings
1. Manually set the date and time of the access point using the section pictured
below.
2. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.