TRENDnet TEW-826DAP, User Manual, Page: 48 / 72

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
45
SNMP Settings
Management > SNMP Settings
SNMP (Simple Network Management Protocol) is a network management protocol used
to monitor (read) and/or manage (write) multiple network devices on a network
through a preconfigured external SNMP server.
1. Log into your management page (see “ Access the management page ” on page
8).
2. Click on the Management tab and click SNMP Settings.
3. Review the settings and click Save to save settings.

SNMP: Select enable to enable SNMP feature

Contact: Enter the contact person or contact information for your access
point.

Location: Enter an assigned location for your access point.

Community Name (Read only): Enter an assigned name for your access
point.

Community (Read/Write): Enter a public and private community name.

Trap Destination Address: Enter the destination IP address of the SNMP
trap.

Trap Destination Community Name: Enter the name of the destination
community

SNMPv3: Select option to enable or disable SNMPv3

Username: Enter the username

Auth Protocol: Select from the pull down menu the authentication
protocol to use

Authentication Key: Enter the authentication key

Priv Protocol: Select the private protocol

Priv Key: Enter the private key

Engine ID: Enter the engine name
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.