© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-824DRU
40
Access Control (IP Protocol Filter)
Advanced > Security > Access Control
You may want to block computers or devices on your network access to specific ports
(used or required by a specific application) to the Internet.
Block a specific service or multiple services
1. Log into your router management page (see “
Access your router management page
on page 9).
2. Click on
Advanced
and click on
Security,
then click on
Access Control
.
3. Next to
Enable Access Control
, click the
Enable
option.
4. Review the
Add Services Block Rule
. Click
Add
to save the rule.
Rule Enable
– Checking this option turns on the Protocol/IP Filter and
unchecking turns it off.
Rule Name
– Enter a name for the Protocol/IP Filter.
Schedule (Optional) –
The schedule function allows you to define a schedule
when the access control filter should be turned on. T To define a new schedule,
click
New Schedule
and refer to page 39 “
”. After you have
created a new schedule, click the drop-down list and the new schedule will be
available for selection.
Note:
Before applying scheduling, please ensure your Time
settings are configured correct and you have defined a schedule. See page 38 to
configure
” to create a schedule.
Client IP Address Range
– Enter the IP address or IP address range to apply the
protocol/IP filter. (e.g.
192.168.10.20-192.168.10.20
or
192.168.10.20-
192.168.10.30)
.
Note:
The filter will not be applied to IP addresses outside of the range
specified.
To simplify configuration, there is a list of commonly used pre-defined Protocol/IP Filters
to modify otherwise, you can choose to manually add a new Protocol/IP Filter.
Service
– Select
Predefined
to select from the predefined services listed or
select
Manually
to specifically enter the TCP or UDP port number or port range
numbers to block. (e.g.
80-80
or
20-21
).
Summary of Contents for TEW-824DRU
Page 1: ...TRENDnet User s Guide Cover Page...
Page 72: ......
