©
Copyright
2013
TRENDnet.
All
Rights
Reserved.
TRENDnet
User’s
Guide
TEW
‐
733GR
15
Internet Connection Type – Dynamic IP (DHCP)
The default WAN configuration for this router is Dynamic IP (DHCP). This option
allows the router to obtain an IP address automatically from the device that is
connected to the Internet port.
Host Name:
The Host Name is optional but may be required by some ISPs.
Leave blank if you are not sure.
Use Unicasting:
Tick this option if your ISP uses the unicast method to provide
IP addresses.
Primary DNS Server:
Enter the primary DNS server IP address that is supplied
by your ISP.
Secondary DNS Server:
Enter the secondary DNS server IP address that is
supplied by your ISP.
MTU:
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your specific ISP. 1500 is the default MTU.
MAC Address:
The default MAC Address is set to the Internet port’s physical
interface MAC address on the broadband router. It is not recommended that you
change the default MAC address unless required by your ISP.
Clone Your PC’s MAC Address:
Click to replace the Internet port’s MAC
address with the MAC address of your Ethernet card.
Internet Connection Type – PPPoE (Username / Password)
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE
connection. Your ISP should provide you a username and password. This option
is typically used for DSL services. Make sure to remove your PPPoE software
from your computer. The software is no longer needed and will not work through
a router.
