SM/PRO
-12-
Moving the Combs to the Cutting Position
n
To remove the workpiece off-cut from the rear
material slide, loosen the lock down knobs of the
rear material slide, and lift out off-cut. Lock back
down the knobs to keep secure.
n
Remove the comb assembly lock down knobs and
turn the comb assembly over. (The pin holes are
specific so they cannot be incorrectly located).
n
The comb assembly should now underline the word
“CUT”.
n
Replace the two lock down knobs and lock down
hand tight.
The jig is now set-up to make repeated cuts.
Release plunge on router at end of
each cut.
Please note with some smaller
routers the cutter may not plunge up
inside the base, so extra care must
be taken.