TREND NETWORKS R158003, User Manual

Page: 5 / 32

158800.02 VDV II 4
En
VOICE port
selected
VIDEO port
selected
DATA port
selected
Battery
Low
Indicator
POWER
To remove / insert the battery:
• Remove the battery cover screw
and the battery cover from the
back of the tester.
•
Remove / insert the battery,
taking care to connect correctly
and not to trap the cable.
•
Replace the battery cover and
screw.
To switch the tester ON:
•
Press the ON/OFF button
o The display shows the
selected port (VOICE,
VIDEO or DATA).
o
If the Battery Low Indicator
is shown, the battery
should be replaced with a
new 9V battery.
To switch the tester OFF:
• Press the ON/OFF button.
TERMINATIONS
The Dual Port Remote Unit can be stored in the bottom end of the Tester, with
the jacks either inside for protection or outside for testing patch cables without
removing it from the Tester, and provides internal storage for the Coax Remote
Unit.
Termination
Number
Identifier
Indicator
Remote
Unit
Indicator
CONNECTIONS
To connect to a cable and to confirm correct connection:
• Use the correct port (VOICE, VIDEO or DATA)
according to the cable connector type. (Use VOICE for
RJ11, RJ12, RJ14 or RJ25 cables, VIDEO for F 75 Ω Coax
or DATA for RJ45).
• Press the corresponding port button (VOICE, VIDEO or
DATA).
o The display shows the selected port.
• Connect one end of the cable to the selected port on the
tester and the other end to a Remote Unit for cable
identification and testing or to an Identifier for cable
identification only.
o The display shows the type of terminatIon
(Remote Unit or Identifier) and its Number to
assist identification when a number of different
terminations are in use.
Dual Port Remote Unit
# 1 (Standard)
Coax Remote Unit
# 1 (Standard)
# 1 to 12 (Optional
- 158053)
RJ45 Remote Unit
# 1 to 12 (Optional
- 158050)
RJ45 Identifier
# 1 to 24 (Optional -
158051)
Battery cover
screw
Battery cover