7
Depend On Us
6
www.trend-networks.com
240810 Rev 1.
Once all settings have been
established, touch the check mark
at the bottom of the page.
Manual
limits
may be selected on the OTDR Limits page. The following two
pages of limits will be displayed to set limits/thresholds.
Note:
The Limits and test thresholds will be displayed for review prior to
taking a test.
Load Defaults sets the default lim-
it values that would be industry
standard for each measured item.
Take a trace
by selecting the Test button on the OTDR Setup screen. Once
the Test button is selected, the Test Parameter screen below will be displayed.
This screen displays the limits/thresholds that have been selected for pass/fail
analysis and the parameters set for the trace.
Conducting a Test
If the settings are correct, select the check box to start the test. A scanning
status bar will be displayed, followed by a finding event message.
EN