-
8
-
No Light
The EdgeFire cannot communicate with the network.
RJ45
Checking the LED to Confirm Status
1
13
The LED on the front panel shows the deployment status.
Only Left LED
10Mbps LINK/ACT (off = no link, on = 10 Mbps, blinking = activity)
Only Right LED
100Mbps LINK/ACT (off = no link, on = 100 Mbps, blinking = activity)
Both Left / Right LED GE LINK/ACT (Both LED ON = 1 Gbps link, blinking = activity)
1
1
2
2
1
2
3
4
5
6
7
8
LAN
WAN
USB
CONSOLE
PWR2 PWR1
STATE IPS/IDS
FAULT VPN
MGMT HA
RST
PWR1
PWR2
IEF-1012-TM
EdgeFire
SECURED BY
v+
v-
NA
1
1
2
2
1
2
3
4
5
6
7
8
LAN
WAN
USB
CONSOLE
PWR1 PWR1
STATE IPS/IDS
FAULT VPN
MGMT HA
RST
PWR1
PWR2
IEF-1012-TM
EdgeFire
SECURED BY
RJ45
Appendix: Connecting to the Console Port
The EdgeFire console port is an RJ-45 port located on the front panel of the case. It is
designed for connection to serial console terminals, for viewing messages during the boot
sequence, or for debugging system boot issues. To connect the console cable, remove the
protective cover on the port.
Serial Console Port, Cable, & Pinouts
Initial configuration for the EdgeFire using the command line interface (CLI) on a serial terminal
client will use the following default settings:
• Baud Rate: 115200 bps
• Character size: 8 bits
• Parity: None
• Stop Bits: 1
• Flow Control: None
