Trelawny A70, Operation And Maintenance Manual

Page: 8 / 20

Release the levers that hold the
motor head
.
MAINTENANCE
Lift the motor head by means of the
handles provided and rest this on a
support bench, take not to damage
the power cable.
Remove from underneath the
vacuum cleaner the pin (A) and
spring pin (B) that fasten the filter to
the shaking lever.
Lift out the filter complete with its
support.
Unscrew the clamp and remove the
support ring with seal.
Undo the tied knots from inside (A)
and the underside, then remove the
pocket filter.
Fit the new filter, put everything back
together carefully securing all ties
and fit the cap back on.
The container locking operation
must be performed by one person
only, who must lower the lever with
both hands to lock the canister in
position.
Replacing the filters
To replace the filters, proceed as
follows:
Turn off the vacuum cleaner by
pressing down the motor STOP
switches.
Disconnect the vacuum cleaner plug
from the power socket.
Ensure front wheels are locked.
Lift the lever that locks the
ENDLESSBAG hopper.
Remove the Hopper.
Important:
All material trapped and contained
within the filter must be disposed of
according the local legislation
NOTE:
Do not place hands on sides of
container near the guide pins
while re - installing.
Perform the container locking
operation by means of the lever
located on the front, USE BOTH
HANDS !!
A
B
A
DOWN
UP