treesse ATC System, Instructions For Use Manual

Page: 10 / 16

10
Key P1:
Key P2:
With the power source connected and water level in the tub (5 cm above the level of the nozzles),
pressing this button activates the
Whirlpool
function, the backlight of the icon switches from
dimmed white to bright white. If you want to turn off the feature, press the key again or after
20 minutes of operation.
By pressing the key without having the proper water level in the tub, the function will not be
activated and the icon will start flashing with the LEDs indicating the water level S2 , flashing, too.
* If the system features a temperature regulator, key P1 controls its activation and deactivation, in
relation to the tub, according to the following specifications: ACTIVATION: after holding active the
pump tub for at least 15 sec.
POWER OFF: immediately after pressing the P1 button, which will keep on blinking with the hot tub
still active for 30 seconds (to allow the cooling of the temperature regulator).
Disinfection can be done only when all functions are disabled and the sensor detects the
presence of water in the tub.
To carry out disinfection, follow the steps below:
1) press the
P2 button for 4 seconds > the icon will flash together with key P1 ;
2) confirm the operation by pressing the P2 key once again, within 5 seconds: to confirm within
this limit, the function will abort and the panel will return to its normal state.
During the disinfection phase, the backlighting system of all icons is flashing. No other operations
can be performed during disinfection, which will end automatically after 10 minutes. If the water
level is low during disinfection, the function will end.
When the tub is empty and the disinfection completed, the said state of the display will turn off
after 2 min from the end of operations, for safety reasons ( 2 min safety).
CAUTION: during the disinfection, there should be no people in the tub.
For details on how to fill the disinfection tank, please see page below.
Key P3:
Keys P4:
P4 a
P4 b
With power and water level not necessarily present, pressing this button activates the Airpool
function, the backlight of the icon changes from dimmed white to bright white. If you want to turn
off the feature, press the key again or it will turn off automatically after 20 minutes of operation.
The Airpool function starts by default at maximum speed; to make adjustments press the
keys P4b and P4b (below).
With Airpool function and the adjustment mode enabled, to vary the speed of the
blower you must press the keys
P4a
and
P4b
.
The key
P4a
is disabled and its backlight is off if the blower speed is equal to the minimum
value, and, conversely, P4b is disabled and its backlight is off if the blower speed is equal to the
maximum value.
There are 5 speed adjustment steps.
You can exit the setting mode by pressing the button P3 or waiting for a few seconds.
_RADIO REMOTE CONTROL - HOW TO USE