HARDWARE NEEDED
MB-1- 1/2”-13 Acorn Nut Plated-
(2)
MB-2- 1/2”-13 x 7” Carriage Bolt-
(2)
MB-8- 3/8” x 3 1/2” Hex Lag Screw-
(8)
MB-3- 1/2”-13 Hex Nut-
(2)
MB-12- 1/2” Split Lockwasher-
(2)
MB-14- 3/8” Uss Flatwasher-
(8)
MB-15- 1/2” Uss Flatwasher-
(2)
MB-16- 3/4” Uss Flatwasher-
(2)
PARTS NEEDED
Monkey Bar Overhead Assembly (1)
Support Assembly (1)
CC-190 Left MB Gusset (1)
CC-191 Right MB Gusset (1)
Monkey Bar Assembly
Su
pp
ort As
sembl
y
Overh
ead A
ssemb
ly
M
B
-2
M
B
-16
M
B
-15
M
B
-12
M
B
-3
M
B
-1
CC
-1
90
CC
-1
91
M
B
-1
4
M
B
-8
Grab the Monkey Bar Overhead at the rung that is in the center and pull up scis
-
soring the Monkey Bar Overhead and the Monkey Bar Support. Now facing the
Monkey Bar Support place your Left Monkey Bar Gusset on the inside of the board
and push up until it touches the Monkey Bar Overhead. Have your helper pull out
on the Monkey Bar Support until the notches on the Left Monkey Bar Gusset are
flat against the Monkey Bar Support and the Monkey Bar Overhead. **Be care
-
ful and do not let the assembly scissor back down as this can cause an injury or
damage your Monkey Bars.** Place a 3/8” Flatwasher over a 3/8” x 3 1/2” Hex Lag
Screw and attach the Left Monkey Bar Gusset to the Monkey Bar Overhead and
Monkey Bar Support Ladder. Repeat this process on the right side. Now tighten the
1/2” Hex Nuts, put on the 1/2” Acorn Nut and lightly tighten. Do not over tighten.
6.4
5.8 & 7.5
Ad
j
usment Hole
Ad
j
usment Hole
5.0 PIF
5.8
5.0 PIPC
Parrot Island
J
a
g
uar
