Main Assembly
Parts Needed
SC-4- Slide Component- 4-
(1)
SC-5- Slide Component-5-
(1)
Hardware Needed
SHK-2- 5/16” USS Flatwasher-
(48)
SHK-4- 5/16” x 1” Hex Bolt-
(24)
SHK-6- 5/16” Nylon Locknut-
(24)
Step:
Again the first thing we want to do now is find the inner
and outer seam of SC-4. The inner seam being on the inside of the
curve and the outer seam being on the outside of the curve. When
attaching this part to SC-3 we are going to take the inner seams
and line them up, then rotate SC-4 COUNTER CLOCKWISE two
holes. Then using (2) SHK-2’s (5/16” Flatwashers), (1) SHK-4
(5/16” x 1” Hex Bolt), and (1) SHK-6 (5/16” Nylon Locknut) for
each hole we are going to lag down the part.
** Depending on which way the unit is facing the step may be
reversed**
SC-3
SC-4
Step:
Again the first thing we want to do now is find the inner
and outer seam of SC-5. The inner seam being on the inside of the
curve and the outer seam being on the outside of the curve. When
attaching this part to SC-4 we are going to take the inner seams
and line them up, then rotate SC-5 COUNTER CLOCKWISE two
holes. Then using (2) SHK-2’s (5/16” Flatwashers), (1) SHK-4
(5/16” x 1” Hex Bolt), and (1) SHK-6 (5/16” Nylon Locknut) for
each hole we are going to lag down the part.
** Depending on which way the unit is facing the step may be
reversed**
SC-4
SC-5
